UAS Phenotyping and Aerial Image Acquisition Procedures

From Poland Lab Wiki
Revision as of 18:25, 7 December 2015 by Singhdj2 (Talk | contribs) (Table of Contents)

Jump to: navigation, search

Table of Contents

1. Flight Checklists

 1.1. Pre-Flight Guide – Before Leaving For Field
      
     1.1.1. UAS Accessory List
     1.1.2. Things to check before leaving lab
 
 1.2. Field-setup Guideline
 
 1.3. At-field- Pre-Flight Checklist 
      
     1.3.1. Camera settings
 
 1.4. At-Field- In-Flight Checklist
 
 1.5. Post-Flight Checklist
 
 1.6. Ground Truthing and Agronomic Notes (Optional)

2. How-to Guide

 2.1. CHDK Installation on SD Card
 
 2.2. Camera Settings
 
 2.3. Mission Planner Program and Driver Installation
 
 2.4. Ground Map Caching on Mission Planner
 
 2.5. Mission Planning 
 
 2.6. Downloading Data Flash Logs
 
 2.7. Preparing Data For Archiving

1. Flight Checklists

  1.1. Preflight Checklist – Before Leaving for Field
      
      1.1.1. UAS accessory list
             
             ❏	Transmitter
             ❏	Radio with USB cable
             ❏	UAV batteries and battery chargers
             ❏	Propellers and extra propellers
             ❏	Tool kit (wrench set, propeller hex-key, camera mount screws and screw driver etc.)
             ❏	Gimbal
             ❏	Camera(s) with fully charged batteries 
             ❏	SD cards with CHDK installed
             ❏	Voltmeter (optional)
             ❏	Calibration reference panel and metal stand (optional)
             ❏	Ground Control Points installed (optional)
      
      1.1.2. Things to check before leaving for field
             
             ❏	An updated version of Mission Planner Software is installed on the field laptop. 
             ❏	Has the field map been cached in the Mission Planner program ? Details on map caching procedure are discussed below in section x.x. 
               (Note: This step is required only once for each new phenotyping field.)
             ❏	Does RC Transmitter have enough voltage?  FrSky transmitter should have ≥ 9.4V charge.  
             ❏	Are UAV batteries charged? 3-cell batteries should charge to 12.6V. 
             ❏	Is the laptop charged? Do you need/have a laptop charger? 
             ❏	Ensure that you are familiar with the laws and regulations related to flying UAVs in your country/area. General laws in the United States 
               require 400 Feet maximum height and within line-of-sight flying. 
             ❏	Make sure you have watched all the UAV manufacturer recommended tutorials before your first flight.  
             ❏	When first flying your IRIS+, make sure to fly it away from people and in an open area.  
             ❏	Before the first flight make sure to perform a compass calibration otherwise this could lead to a bad behaviour in GPS enabled modes. You can 
                perform the compass calibration through APM Planner or Mission Planner https://www.youtube.com/watch?v=oD9Z9IR2TNU